– 2 –
N
To connect to 2 single-line telephone jacks
1
For Line 1: Connect the “Transparent” plug
telephone line cord (2-wire cord) (
1
) to the unit,
then to the Line 1 single-line telephone jack (RJ11C)
(
2
) until you hear a click.
2
For Line 2: Connect the “
GREEN
” plug telephone
line cord (4-wire cord) (
3
) to the unit, then to the
Line 2 single-line telephone jack (RJ11C) (
4
) until
you hear a click.
Handset battery installation/Handset battery charging
Charge for about 7 hours.
Note:
L
USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
1
).
L
Do NOT use Alkaline/Manganese/Ni-Cd batteries.
L
Confirm correct polarities (
S
,
T
).
L
Follow the directions on the display to set up the unit.
L
Confirm “
Charging
” is displayed (
2
).
Using the unit as a single-line telephone only
1
Connect the “Transparent” plug telephone line cord (2-wire
cord) to LINE 1/2.
Handset/Base unit:
L
To use line 1 only:
{
MENU
}
(
25
)
s
{
r
}
:
“
Line1
”
s
{
SAVE
}
s
{
OFF
}
/
{
EXIT
}
L
To erase the message
“
Check tel line2
”
:
{
MENU
}
(
19
)
Connecting the telephone line cord
3
2
1
2
4
1
“Transparent” plug
“
GREEN
”
plug
If you subscribe to a DSL/ADSL service, attach a DSL/ADSL filter to the telephone line between the base
unit and the telephone line jack. Refer to the operating instructions for connections.
1
2
1
TG958x_(en)_QG.fm Page 2 Thursday, July 3, 2014 3:38 PM
