Useful Information
20
For assistance, please visit http://www.panasonic.com/phonehelp
Troubleshooting
Problem
Cause & solution
The cordless camera
does not work.
L
Check the connections (page 8).
L
The cordless camera is not registered to the base unit.
Register the cordless camera to the base unit (page
12).
The cordless camera’s
indicator is flashing red.
L
The cordless camera is not registered to the base unit.
Register the cordless camera to the base unit (page
12).
L
The cordless camera is out of range. Locate the
cordless camera near the base unit.
The image is faint.
L
The camera lens is dirty. Clean it with a soft dry cloth.
L
Do not touch the lens directly. Fingerprint may cause an
unclear image.
The image sent from the
cordless camera is poor
on the handset display.
L
Adjust the display brightness setting (page 15).
L
Select standard quality mode instead of enhanced
motion mode (page 10).
L
The place where the cordless camera is located is dark.
Improve lighting.
The image sent from the
cordless camera is dark
and difficult to see on the
handset display.
L
Adjust the display brightness setting (page 15).
L
There is a strong sunlight or a backlight in the place
where the cordless camera is located. Try shading the
camera’s location.
I cannot connect to the
cordless camera, the
image distorts, or the
image is slow.
L
The cordless camera has lost communications with the
base unit. Move the cordless camera closer to the base
unit, and try again.
L
There is an obstacle such as concrete wall. Move the
cordless camera to the place without an obstacle.
L
A microwave appliance is in use. Move the cordless
camera closer to the base unit or use the cordless
camera away from that appliance, and try again.
The camera sensor does
not respond.
L
If you set the audio detection sensitivity to off, the
camera sensor does not respond. Turn this feature on
(page 16).
L
While a handset is monitoring the cordless camera, the
cordless camera stops detecting sound.
TGA573(e).book Page 20 Monday, April 24, 2006 2:05 PM
