Useful Information
46
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Battery recharge
Making/answering calls, intercom
I cannot activate the
eco mode.
L
You cannot set eco mode when you set the repeater
mode
“
On
”
. If required, set the repeater mode to
“
Off
”
(page 30).
I cannot register a
handset to a base unit.
L
The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 30).
L
You entered the wrong PIN. If you forget your PIN, see
“I cannot remember the PIN.” (page 46).
I cannot remember the
PIN.
L
Change the PIN using the following method.
1
8
i
{
#
}{
1
}{
3
}{
2
}
2
{*}{
7
}{
0
}{
0
}{
0
}
3
Enter the new 4-digit base unit PIN.
i
M
i
{i
c
}
Problem
Cause/solution
The handset beeps
and/or
)
flashes.
L
Battery charge is low. Fully charge the batteries (page
10).
I fully charged the
batteries, but
–
)
still flashes or
– the operating time
seems to be shorter.
L
Clean the battery ends (
S
,
T
) and the charge
contacts with a dry cloth and charge again.
L
It is time to replace the batteries (page 10).
The handset display is
blank.
L
The handset is not turned on. Turn the power on (page
14).
Problem
Cause/solution
_
is displayed.
L
The handset is too far from the base unit. Move closer.
L
The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
L
The handset is not registered to the base unit. Register
it (page 29).
L
Activating one touch eco mode reduces the range of
the base unit in standby mode. If required, turn eco
mode off (page 15).
Problem
Cause/solution
TG6561E(e).book Page 46 Tuesday, July 13, 2010 1:50 PM
