7
Battery charge
Place the handset on the charger for about 7 hours before initial use.
• The charge indicator lights up when the handset is placed on the charger.
Note:
• The handset display may show
“
Please Wait...
”
when the handset is
placed on the charger if it is not registered to a base unit.
Registering the handset to the KX-TG7100/KX-TG7120
base unit
Ensure that the handset is switched on. If it is not on, press and hold
{ih}
for few seconds to turn the handset on.
1
Lift the handset and press
{ih}
to put the handset in standby mode.
2
Press and hold
{x}
on the base unit for about 3 seconds, until the
registration tone sounds.
3
Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and
w
stops flashing.
Note:
• If an error tone sounds, or if
w
is still flashing, register the handset
manually. (See manual registration in the KX-TG7100/KX-TG7120
operating instructions.)
• If all registered handsets start ringing in step 2, press
{x}
to stop. Start
again from step 1.
• Charge the batteries for about 7 hours before initial use.
• The KX-TG7100 does not feature an answering system.
• Answering system features are available only when this handset is
registered to the KX-TG7120.
TGA711EX(ex).book Page 7 Friday, March 10, 2006 2:04 PM
Summary of Contents for KX-TGA711EX
Page 2: ...2 25 mm Screws 25 mm Hooks TGA711EX ex book Page 2 Friday March 10 2006 2 04 PM ...
Page 73: ...TGA711EX ex book Page 73 Friday March 10 2006 2 04 PM ...
Page 74: ...TGA711EX ex book Page 74 Friday March 10 2006 2 04 PM ...
Page 75: ...TGA711EX ex book Page 75 Friday March 10 2006 2 04 PM ...
