2
Enter the current 4-digit base unit PIN
(default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
a
M
N
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 3. Contact your Panasonic dealer for
details.
Important:
R
Before registering the repeater to this base
unit, you must turn the repeater mode on.
R
Do not use more than one repeater at a
time.
Setting the repeater mode
1
M
N#138
2
MbN
: Select the desired setting.
a
M
OK
N
a
M
N
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R
Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold
M
N
for about 5 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and
indicator light
green.
3
Base unit:
To exit the registration mode, press
M
N
.
24
Programming
TGC2xxCX_(en)_0530_ver002.pdf 24
2014/05/30 15:36:24