Answering system
Problem
Cause/solution
The unit does not record
new messages.
R
The answering system is turned off. Turn it on (page 38).
R
The message memory is full. Erase unwanted messages
(page 39).
R
The recording time is set to
“
Greeting Only
”
. Change the
setting (page 43).
R
Your phone service provider’s voicemail service may be
answering your calls before the unit’s answering system can
answer your calls. Change the unit’s number of rings setting
(page 43) to a lower value, or contact your phone service
provider.
R
The answering system will not answer incoming calls while the
other devices such as handsets are engaged in a call.
I cannot operate the
answering system
remotely.
R
The remote access code is not set. Set the remote access
code (page 42).
R
You are entering the wrong remote access code. If you have
forgotten your remote access code, enter the remote access
code setting to check your current code (page 42).
R
The answering system is turned off. Turn it on (page 43).
The unit does not emit the
specified number of rings.
R
If the first ring is turned off (page 25), the number of rings
decreases by 1 from the specified number of rings.
Liquid damage
Problem
Cause/solution
Liquid or other form of
moisture has entered the
handset/base unit.
R
Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorised service centre.
Caution:
R
To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
51
Useful Information
TGD31x_32xE(en)0202_ver201.pdf 51
2015/02/02 14:00:42
