5
M
MENU
N
a
MbN
:
“
Erase
”
a
M
OK
N
6
MbN
:
“
Yes
”
a
M
OK
N
a
M
OFF
N
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R
This feature cannot be set during a
monitoring call.
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
Sensitivity Level
”
a
M
OK
N
3
MbN
: Select the desired setting.
a
M
OK
N
a
M
OFF
N
Answering the baby monitor
n
When monitoring with a handset:
Press
M
N
to answer calls.
If you want to respond from the monitoring
handset, press
M
MUTE
N
.
R
The monitoring handset will answer calls
automatically when the auto intercom
feature is set to
“
On
”
(page 19).
Note:
R
If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds. To
answer the call, press
M
OFF
N
, then press
M
N
.
n
When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press
#1
using tone dialling.
You can turn off the baby monitor feature
by pressing
#0
.
Note:
R
The unit disconnects the call
automatically after 2 minutes.
Other programming
Changing the handset name
The default handset name is
“
Handset 1
”
to
“
Handset 6
”
. You can customise the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 33).
1
M
MENU
N#104
2
Enter the desired name (10 characters
max.).
3
M
OK
N
a
M
OFF
N
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is
“
Off
”
.
1
M
MENU
N#105
2
MbN
: Select the desired setting.
a
M
OK
N
a
M
OFF
N
Call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
M
MENU
N#256
2
Enter the base unit PIN (default:
“
0000
”
).
R
If you forget your PIN, see page 49.
3
MbN
: Select the handsets to be restricted.
a
M
SELECT
N
R
“ ” is displayed next to the selected
handset numbers.
R
To cancel the selected handsets:
MbN
: Select the handset.
a
Press
M
SELECT
N
again. “ ” disappears.
4
M
OK
N
5
MbN
: Select a memory location.
a
M
OK
N
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
33
Programming
TGD31x_32xE(en)0202_ver201.pdf 33
2015/02/02 14:00:40
