Problem
Cause/solution
I cannot remember the
PIN.
R
Change the PIN using the following method.
1
M
MENU
N#132
2
*7000
3
Enter the new 4-digit base unit PIN.
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
a
M
OFF
N
Battery recharge
Problem
Cause/solution
The handset beeps and/or
flashes.
R
Battery charge is low. Fully charge the batteries (page 12).
I fully charged the
batteries, but
–
still flashes or
– the operating time
seems to be shorter.
R
Clean the battery ends (
,
) and the charge contacts with
a dry cloth and charge again.
R
It is time to replace the batteries (page 11).
Making/answering calls, intercom
Problem
Cause/solution
is displayed.
R
The handset is too far from the base unit. Move closer.
R
The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R
The handset is not registered to the base unit. Register it
(page 34).
R
Activating eco mode reduces the range of the base unit in
standby mode. If required, turn eco mode off (page 16).
Noise is heard, sound cuts
in and out.
R
You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R
Move closer to the base unit.
R
If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
Sound quality seems to be
getting worse.
R
You have registered a handset that is not recommended
(page 5). The clearest sound quality is only possible by
registering the recommended handset.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
49
Useful Information
TGD31x_32xE(en)0202_ver201.pdf 49
2015/02/02 14:00:41