Main menu: “
Ringer Setup
”
*14,
*15
Sub-menu 1
Sub-menu 2
Settings
Code
Ringer Volume
Handset
Off
-6 <6>
#160
–
Base Unit
*1,
*2
Off
-6 <3>
#
G
160
–
Ringtone
*5
(Handset)
–
<
Ringtone 1
>
#161
–
Do Not Disturb
Mode
On/Off
On
<
Off
>
#238
29
Start/End
<23:00/06:00>
#237
29
Ring Delay
30 sec.
<
60 sec.
>
90 sec.
120 sec.
No Ringing
#239
29
Select Category
Category 1-9
#241
29
First Ring
*2,
*6
–
<
On
>
Off
#173
–
Main menu:
“
Nuisance Call Block
”
*2,
*16
Sub-menu 1
Sub-menu 2
Settings
Code
Single Number
–
–
#217
29
Range of Numbers
–
–
Withheld
–
On
<
Off
>
#240
30
*1 KX-TGD320 series: page 3
*2 If you program these settings using one of the handsets, you do not need to program the
same item using another handset.
*3 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*4 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID
”
. To turn this feature off, select
“
Manual
”
.
(Caller ID subscribers only)
To use this feature, set the date and time first (page 13).
*5 The preset melodies in this product are used with the following permission:
–
“
Ringtone 3
”
: © 2014 Copyrights Vision Inc.
–
“
Ringtone 4
”
-
“
Ringtone 40
”
: © 2012 Copyrights Vision Inc.
*6 If you do not want the unit to ring before the caller information is received, set to
“
Off
”
.
(Caller ID subscribers only)
You can only remove the first ring if the unit rings 2 times or more by default, which depends
on your phone service provider.
*7 This setting is available when you have the key finder (KX-TGA20AZ). Read the installation
manual for more information on the key finder.
*8 For models with supplied key finders, the display shows
“
1:Finder1
”
.
27
Programming
0303_TGD3xxNZ(en-en)_ver002.pdf 27
2015/03/03 10:28:04