Answering system
Problem
Cause/solution
The unit does not record new
messages.
R
The answering system is turned off. Turn it on (page 51).
R
The answering system does not answer or record calls
from cellular lines.
R
The message memory is full. Erase unnecessary
messages (page 52).
R
The recording time is set to
“
Greeting only
”
. Change
the setting (page 55).
R
Your phone service provider’s voicemail service may be
answering your calls before the unit’s answering system
can answer your calls. Change the unit’s number of rings
setting (page 54) to a lower value, or contact your phone
service provider.
R
The answering system will not answer incoming calls
while the other devices such as headset or handsets are
engaged in a call.
I cannot operate the answering
system remotely.
R
The remote access code is not set. Set the remote
access code (page 53).
R
You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 53).
R
The answering system is turned off. Turn it on (page 54).
R
You cannot operate the answering system when calling a
cellular phone paired to the base unit.
The unit does not emit the
specified number of rings.
R
If the first ring is turned off (
“
No
”
) (page 26), the number
of rings decreases by 1 from the specified number of
rings.
Bluetooth PIN
Problem
Cause/solution
I cannot remember the PIN.
R
Change the PIN using the following method.
1
M
MENU
N#619
2
*7000
3
Enter the new 4-digit PIN.
a
M
OK
N
4
Enter the new 4-digit PIN again.
a
M
SAVE
N
a
M
OFF
N
68
For assistance, visit www.panasonic.ca/english/support
Useful Information
KX-TG273CSK̲(en-en)̲0525̲ver110.pdf 68
2018/06/02 10:39:12
