Recording your greeting
message
You can record your own greeting message
instead of using a pre-recorded greeting
message. See page 38 for details.
1
M
MENU
N#302
2
MbN
:
“
Yes
”
a
M
OK
N
3
Record a greeting message.
a
M
STOP
N
a
M
N
Other settings
Smart Function Key (
key)
The Smart Function Key (
key) is located
on the bottom of the handset and informs you
with its flashing to allow you to activate the
following features by simply pressing this key.
n
When the
indicator flashes rapidly,
you can:
– Answer the call (outside call, intercom).
– Stop paging. (page 19)
– Stop the alarm sound. (page 30)
n
When the
indicator flashes slowly in
standby mode, you can:
– Listen to new messages. (page 40)
– View the caller list when there are
missed calls. (page 37)
To activate these features, their Smart
Function Key must be “On”. (page 15)
Using the Smart Function Key (
key)
When the
indicator flashes rapidly/slowly,
press
M
N
.
R
The above features can be activated
depending the situation.
R
If you answer a call using the Smart
Function Key, the speakerphone is
activated.
R
Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
R
When the unit has new messages and
missed calls, the unit can be operated to
play the new messages first and then show
the missed calls.
Note:
R
While key lock is on (page 20), incoming
calls can be answered, but the following
features are disabled even when the
indicator flashes slowly.
– Listen to new messages. (page 40)
– View the caller list when there are
missed calls. (page 37)
Setting the Smart Function Key
The Smart Function Key for the following
features must be “On”.
–
“
New Message
”
(Default: On)
–
“
Missed Call
”
(Default: Off)
The settings can be set for each handset.
1
M
MENU
N#278
2
MbN
: Select the desired setting and press
M
SELECT
N
.
R
“ ” is displayed next to the selected
features.
R
To cancel a selected feature, press
M
SELECT
N
again. “ ” disappears.
3
M
OK
N
a
M
N
Note:
R
If the
indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.
Eco mode setting
You can select the desired eco mode setting
by pressing
M
R/ECO
N
.
The following settings are available for eco
mode.
–
“
Eco
”
: Reduces the base unit transmission
power by up to 90 % in standby mode.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
15
Getting Started
TGE2xxE_(en_en)_0307_ver.030.pdf 15
2014/03/07 15:08:32