Note:
R
The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to
“
On
”
.
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
On/Off
”
a
M
OK
N
3
MbN
:
“
Off
”
a
M
OK
N
a
M
N
Editing an outside monitoring number
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
On/Off
”
a
M
OK
N
3
MbN
:
“
On
”
a
M
OK
N
4
MbN
: Select the outside line.
a
M
EDIT
N
5
M
MENU
N
a
MbN
:
“
Edit
”
a
M
OK
N
6
Edit the name if necessary.
a
M
OK
N
7
Edit the phone number if necessary.
a
M
OK
N
2 times
Erasing an outside monitoring
number
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
On/Off
”
a
M
OK
N
3
MbN
:
“
On
”
a
M
OK
N
4
MbN
: Select the outside line.
a
M
EDIT
N
5
M
MENU
N
a
MbN
:
“
Erase
”
a
M
OK
N
6
MbN
:
“
Yes
”
a
M
OK
N
a
M
N
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R
This feature cannot be set during a
monitoring call.
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
Sensitivity Level
”
a
M
OK
N
3
MbN
: Select the desired setting.
a
M
OK
N
a
M
N
Answering the baby monitor
n
When monitoring with a handset:
Press
M
N
to answer calls.
If you want to respond from the monitoring
handset, press
M
MUTE
N
.
R
The monitoring handset will answer calls
automatically when the auto intercom
feature is set to
“
On
”
Note:
R
If you receive an outside call when
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press
M
N
, then press
M
N
.
n
When monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press
#1
using tone dialling.
You can turn off the baby monitor feature
by pressing
#0
.
Note:
R
2 minutes after the monitored handset
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.
Other programming
Changing the handset name
The default handset name is
“
Handset 1
”
to
“
Handset 6
”
. You can customise the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 34).
1
M
MENU
N#104
2
Enter the desired name (10 characters
max.).
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
33
Programming
TGE2xxE_(en_en)_0307_ver.030.pdf 33
2014/03/07 15:08:33
