Transferring a cellular call from a
cellular phone to the handset
During a conversation using a cellular phone,
the call cannot be transferred to the handset
by the cellular phone. Perform the following
with the handset.
1
During a conversation using a cellular
phone, press
M
CELL
N
.
R
The call is transferred to the handset in
the following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 22).
2
MbN
: Select the corresponding cellular
phone.
a
M
SELECT
N
R
The call is transferred to the handset.
Answering a 2nd call
If you receive a call while talking on the phone,
the interrupt tone sounds (page 46) and the
2nd caller’s information is displayed if you
subscribe to Caller ID service (page 56).
Answering a 2nd call during a
landline call
1
Press
M
MENU
N
during a landline call.
2
MbN
:
“
Hold
”
a
M
SELECT
N
3
To answer the 2nd call:
Press
M
CELL
N
while the 2nd call is being
received.
4
To hang up the 2nd call and return to the
1st call (landline call), press
M
OFF
N
, then
press
M
N
.
Answering a 2nd call during a cellular
call
1
Press
M
MENU
N
during a cellular call.
2
MbN
:
“
Hold
”
a
M
SELECT
N
3
To answer the 2nd call:
Press
M
N
or
M
CELL
N
while the 2nd call
is being received.
4
To hang up the 2nd call and return to the
1st call (cellular call), press
M
OFF
N
, then
press
M
CELL
N
.
*1 If you press
M
CELL
N
and the selection list
is displayed, select the desired cellular
line and press
M
SELECT
N
.
Power backup operation
for landline
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive landline calls using a
handset during a power failure. The base unit
will not perform any other functions. However,
some functions such as Caller ID and
phonebook are available only when using a
handset other than the handset supplying
power to the base unit. You can program
“
Power failure
”
and the default setting is
“
Auto
”
(page 48).
Important:
R
If a handset is not placed on the base unit
when a power failure occurs,
“
Power
outage Press OFF
”
is displayed. After
pressing
M
OFF
N
on the handset, place it on
the base unit to start power backup mode.
R
Power backup mode will not work if the
battery level of the power supplying
handset is or .
R
Do not lift the power supplying handset
from the base unit during power backup
mode.
Panasonic Ni-MH battery
performance (supplied batteries)
during power backup mode
When the batteries are fully charged,
operating time of the handset in power backup
mode varies depending on usage.
– Continuous use of the handset in power
backup mode: 1.5 hours max.
– Continuous use of the handset other than a
handset in power backup mode: 2 hours
max.
For assistance, please visit http://shop.panasonic.com/support
27
Making/Answering Calls Using the Handset
Summary of Contents for KX-TGFA51
Page 3: ...Index Index 101 3 Table of Contents ...
Page 103: ...103 Notes ...
