:
Programming using the Base Unit
32
Document Version 2011-03
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 32)
– using the direct commands (page 33)
Some of the features can be programmed through the Web user interface (page 39).
L
Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
{
MENU
}
(middle soft key)
2
Press
{^}
,
{V}
,
{
<
}
, or
{
>
}
to select the desired main menu.
i
{
SELECT
}
3
Press
{V}
or
{^}
to select the desired item in sub-menu 1.
i
{
SELECT
}
L
In some cases, you may need to select from sub-menu 2.
i
{
SELECT
}
4
Press
{V}
or
{^}
to select the desired setting.
i
{
SAVE
}
L
This step may vary depending on the feature being programmed.
L
To exit the operation, press
{
EXIT
}
.
Note:
L
See page 33 for the default settings.
L
In the following table, ( ) indicates lines you need to select for the settings.
Main menu
Sub-menu 1
Sub-menu 2
Page
Line status
m
–
–
IP service
Network setting
DHCP
–
IP settings
–
Embedded web
Call features
Call forward
(Line 1: 8 max.)
–
Unconditional
–
Busy
–
No answer
Do not disturb
(Line 1: 8 max.)
Block anonymous
(Line 1: 8 max.)
Block Caller ID
(Line 1: 8 max.)
Ringer settings
(
Ringer volume
–
Ringer tone
(Line 1: 8 max.)
–
Interrupt tone
–
–
