Registering a Unit
40
Document Version 2011-03
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example,
_
is
displayed even when the handset is near the base
unit), re-register the handset.
1
Handset:
{
MENU
}
(center of joystick)
i
{#}{
1
}{
3
}{
0
}
2
Base unit:
Press and hold
{
ALL
}
for about 4 seconds
until the registration tone sounds and the
STATUS indicator flashes in red.
L
If all registered handsets start ringing, press
the same button to stop. Then repeat from
step 1.
L
The next step must be completed within 90
seconds.
3
Handset:
Press
{
OK
L
}
, then wait until a long beep
sounds.
L
When the handset has been registered
successfully,
_
will change to
w
.
Note:
L
When you purchase an additional handset, refer
to the additional handset’s installation manual
for registration.
Deregistering a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored to
the base unit. This allows the handset to end its
wireless connection with the system.
1
{
MENU
}
(center of joystick)
i
{#}{
1
}{
3
}{
1
}
2
{
3
}{
3
}{
5
}
i
{
OK
}
3
{V}
/
{^}
: Select the desired unit.
i
{
SELECT
}
4
{V}
/
{^}
:
“
Yes
”
i
{
SELECT
}
L
When you cancel a different handset than
the one you are now using, press
{
OFF
}
to
exit.
1
Press and hold
{
ALL
}
until the registration
tone sounds and the STATUS indicator
flashes in red.
L
If all registered handsets start ringing, press
the same button to stop. Then repeat this
step.
2
Press and hold the handset number (
{
1
}
–
{
6
}
) that you want to cancel until a
confirmation tone sounds.
Y
Handset
:
Base unit
