Settings
12
Caller ID Number Auto Edit
Once you call back an edited number (p. 19), this unit can automatically
edit incoming phone numbers from the same area code in the Caller List
and each time you receive a call. For example, it can ignore the area code
of calls originating from your area code, so that you can call these numbers
from the Caller List without dialing the area code.
To activate this feature,
you must edit a caller’s phone number in the
Caller List (p. 19) by selecting pattern
,
, or
, then make a call to that
number. Calls from numbers in that area code will be edited automatically.
The unit can remember up to 4 area codes to be edited according to
patterns
and .
When more than 5 area codes are edited, older area codes are reset to
pattern
. Phone numbers from the 4 most recently edited area codes will
be automatically edited. You can turn this feature on or off. The factory
preset is ON.
To turn Caller ID Number Auto Edit ON or OFF
1
Press
[FUNCTION/EXIT]
.
2
Scroll to “
SET AUTO EDIT ?
”
by pressing
[ ]
or
[ ]
.
3
Press
[ENTER]
.
4
Select “
OFF
” or “
ON
” by pressing
[ ]
or
[ ]
.
5
Press
[ENTER]
.
• If you fail to reach your destination when making a call, the phone number you
dialed might have an incorrect pattern. Edit the phone number with another
pattern (p. 19).
• When this feature is turned off, the unit will still be able to display Caller ID, but
incoming Caller ID numbers will not be automatically edited.
• If you move to another area, you may need to turn this feature off to erase the
previously edited area codes. To use this feature again, turn it on and reprogram
the area codes you want to edit once again.
a
b
c
a
b
c
SET AUTO EDIT ?
▼
▼
:ON
▼
▼
SAVED
E-PQQX14369ZA.book 12 ページ ２００４年１２月１０日 金曜日 午後４時１分
