2.14 Initializing the VPS During Installation
Before programming the VPS for the first time, perform the initialization procedure described below. All settings
are reset to their default values.
Recorded messages are erased.
System prompts (including customized
prompts) are preserved.
1.
Turn the power switch to the off position.
2.
Set the Mode Switch to position 5 (see 2.3 Names and Locations).
0
1
1 2 3 4
3.
Turn the power switch to the on position.
4.
Confirm that the
RUN
indicator blinks 5 times.
•
This may take several minutes. The
ALARM
indicator and
RUN
indicator will first blink intermittently
before the
RUN
indicator blinks 5 times.
5.
Turn the power switch off at the VPS.
6.
Set the Mode Switch to position 0.
0
1
1 2 3 4
7.
Turn the power switch back on at the VPS.
After initializing the VPS, continue with the installation procedure and/or begin programming the VPS.
74
Installation Manual
Document Version 3.0 2010/06
2.14 Initializing the VPS During Installation
Summary of Contents for KX-TVA50
