Value Range
IP address in dotted-decimal notation ("n.n.n.n" [n=0–255]) (Max.
15 digits)
Default Value
Not stored.
4.3.6.2 Enable Global IP Address Usage per Line
Line 1–Line x
Description
Selects whether to enable the NAT Traversal feature for each line.
Note
•
The number of lines available varies depending on the phone
being used, as follows:
–
KX-UT113/KX-UT123: 1–2
–
KX-UT133/KX-UT136: 1–4
–
KX-UT248: 1–6
Value Range
•
Yes
•
No
Default Value
No
4.3.6.3 External RTP Port
Channel 1–25
Description
Specifies the external RTP port number used for voice communication
for each channel.
Note
•
The number of channels available varies depending on the
phone being used, as follows:
–
KX-UT113/KX-UT123: 1–3
–
KX-UT133/KX-UT136/KX-UT248: 1–25
Value Range
0, 1024–49150 (0: Disable, even number only)
Note
•
Each channel must be set to a unique port number, and all port
numbers must be an even number.
•
You cannot specify here the same port number as any of the
port numbers specified for the individual lines in
[Source
Port]
specify a port number that is 1 less than a port number specified
in
[Source Port]
if the source port number is an odd number.
•
All channels must be set to either enable or disable at the same
time.
Default Value
0
92
Administrator Guide
Document Version 2012-06
4.3.6 Static NAPT Settings
Summary of Contents for KX-UT248-B
