1.
The device loads the configuration settings stored on the flash memory. These settings are either the
factory default settings or the settings that were previously changed when restarting.
2.
The device checks if the provisioning URL setting has been changed manually either by web programming
or phone programming.
If it has been changed manually, go to step 8.
If it has not been changed manually, go to the next step.
3.
If SIP PnP is enabled, the device sends a multicast SIP SUBSCRIBE message. The device waits for a
response and then checks whether a SIP NOTIFY reply is received that contains the provisioning URL
setting in the body of the message.
If a valid SIP NOTIFY is received, go to step 8.
If a valid SIP NOTIFY is not received, go to the next step.
4.
If DHCP option 160 is enabled, the device checks whether DHCP option 160 has been received.
If it has been received, go to step 8.
If it has not been received, go to the next step.
5.
If DHCP option 159 is enabled, the device checks whether DHCP option 159 has been received.
If it has been received, go to step 8.
If it has not been received, go to the next step.
6.
If DHCP option 66 is enabled, the device checks whether DHCP option 66 have been received.
If it has been received, go to step 8.
If it has not been received, go to the next step.
7.
If none of the above steps could be applied, the device sends an HTTP request to the Panasonic redirection
server.
If successful, go to step 8. If it fails, go to step 9.
8.
The device attempts to download the initial configuration file.
If it can be downloaded, the device downloads the device configuration file.
If it cannot be downloaded, go to the next step.
9.
The device checks whether there are any locally saved configuration files.
If there are locally saved configuration files, the settings are applied.
If there are no locally saved configuration files, provisioning has failed.
The device will try provisioning again according to the interval specified by the CFG_RTRY_INTVL
parameter.
2.4 Configuration File
2.4.1 Configuration File Format
The configuration file must meet the following conditions.
•
XML format
•
Maximum file size of 240 KB
•
Must be begin with the element
PANASipPhoneConfig
, followed by the "initial" element, which indicates
initial configurations, and the "device" element, which indicates device configurations.
The initial configuration file may contain the following.
•
Root certification URL
•
Configuration URL
Document Version 2014-04
Administrator Guide
41
2.4.1 Configuration File Format
Summary of Contents for KX-UTG200
Page 188: ...188 Administrator Guide Document Version 2014 04 4 9 4 Sniffer Dump...
Page 284: ...284 Administrator Guide Document Version 2014 04 5 8 SSH Settings...
Page 302: ...302 Administrator Guide Document Version 2014 04 7 5 SSH Settings Debug Settings...
Page 303: ...Index Document Version 2014 04 Administrator Guide 303...
