Using a Headset
If a headset is connected, you must enable Headset
mode by pressing
[HEADSET]
.
Note
•
The Headset button light shows the current
status as follows:
Off: Headset mode off
Red: Headset mode on
Setting Up the Unit
The user settings can be used to setup the unit by
configuring the settings as required. See Page 39 for
information about the settings.
Maintaining the Unit
Resetting the Unit
Resetting all settings except for private
settings
Executing "Exclude Private Settings" resets all settings
except for private settings. Private settings include
ringtone volume, brightness, phonebook, and call
history.
1.
On the Home screen, select
.
2.
Press
[ ]
or
[ ]
to select "Reset", and then press
[ENTER]
.
3.
Press
[ ]
or
[ ]
to select "Exclude Private
Settings", and then press
[ENTER]
.
4.
Press
Yes
.
•
To cancel, press
No
.
Resetting all settings except for network
settings
Executing "Reset Excluding Network Settings" resets
all settings except for network settings. Private settings
are reset in this case. Network settings include IPv4,
IPv6, LLDP Settings, CDP Settings, VLAN Settings,
Speed/Duplex, and Port Mirroring.
1.
On the Home screen, select
.
2.
Press
[ ]
or
[ ]
to select "Reset", and then press
[ENTER]
.
3.
Press
[ ]
or
[ ]
to select "Exclude Network
Settings", and then press
[ENTER]
.
4.
Press
Yes
.
•
To cancel, press
No
.
Restarting the Unit
When some of the settings on the unit have been
changed via Web user interface programming or
configuration file programming, the unit must be
restarted.
1.
On the Home screen, select
.
2.
Press
[ ]
or
[ ]
to select "Restart", and then press
[ENTER]
.
3.
Press
Yes
.
•
To cancel, press
No
.
70
Operating Instructions
Document Version 2014-11
Installation and Setup
