•
When the Digital Boundary Microphone is
mute, the sound made by pressing the MIC
Mute button might make
"
"
appear.
5.
Press
[G]
.
•
A dialogue box to confirm the saving of settings
is displayed.
6.
Use
[
][
]
to select
"Yes"
and press
[ENTER]
.
•
The system settings screen is displayed.
Note
•
Do not move Digital Boundary Microphones
after completing settings. Otherwise the
settings will not match the location of the Digital
Boundary Microphone.
Making Remote Control
Settings
You can specify a remote control ID from 1, 2, or 3 for
both the remote control and the unit. The unit responds
to signals from any remote control with the same remote
control ID as itself. If you do not specify an ID, the unit
responds to signals from all remote controls. You can
confirm the remote control ID for the unit on the Home
screen (Page 41).
1.
Select
"Remote Ctrl ID"
and press
[ENTER]
.
•
The remote control settings screen is displayed.
2.
Use
[
][
]
to select the following items for input:
"Remote ID enable"
: Use
[
][
]
to select
"ON"
or
"OFF"
(default).
•
When
"ON"
is selected, you can set a specific
remote control ID for the unit.
•
When
"OFF"
is selected, the unit will respond
to all remote controls.
"Remote control ID"
: Use
[
][
]
to select a
remote control ID (
"ID1"
[default]/
"ID2"
/
"ID3"
) for
the unit.
"Check ID mismatch"
: Use
[
][
]
to select
"ON"
(default) or
"OFF"
.
•
When
"ON"
is selected, if the unit receives a
signal from a remote control that has an ID
different from the one specified on the Home
screen, a warning is displayed. Follow the
procedures on the screen to change the remote
control ID.
•
When
"OFF"
is selected, even if the unit
receives a signal from a remote control that has
an ID different from the one specified, no
warning is displayed on the Home screen.
Note
•
If multiple remote controls with assigned
IDs are being used close together, it is
recommended that you select
"OFF"
for
"Check ID mismatch"
.
3.
Press
[G]
.
•
A dialogue box to confirm the saving of settings
is displayed.
4.
Use
[
][
]
to select
"Yes"
and press
[ENTER]
.
5.
When "Remote ID enable" is set to "ON":
The dialogue box for changing the ID of the remote
control is displayed. Proceed to step
Note
•
While the dialogue box is displayed, video
conference calls cannot be received.
When "Remote ID enable" is set to "OFF":
The system settings screen is displayed. Press
[Home]
to return to the Home screen.
6.
Use the following procedure to change the ID of the
remote control.
1.
Press and hold
[·]
and
[#]
at the same time.
2.
Within 2 seconds after you release the buttons,
press the number (
1
to
3
) corresponding to the
ID that you specified for
"Remote control ID"
–
1
: ID1
–
2
: ID2
–
3
: ID3
7.
Press
[ENTER]
.
•
The dialogue box disappears and the remote
control ID of the unit will be saved.
Note
•
If the dialogue box does not disappear,
repeat the procedure above, several times
if necessary. If the dialogue box still does
not disappear, turn the power off and then
back on to cancel the settings. For details,
contact your dealer.
130
User Manual
Document Version 2018-01
Contacts and Settings
