Making Codec Settings
These settings determine which codecs are enabled and disabled.
Note
•
Changing codec settings may affect the ability to make and receive calls. For details, contact your
dealer.
•
If
"NAT Traversal Mode"
is selected in the connection mode settings, codec settings will not be
displayed.
1.
Select
"Codec Settings"
and press
[ENTER]
.
•
The codec settings screen is displayed.
2.
Select the following items for input.
•
The following items are displayed over 2 pages. Press
[B]
to move to the H.323 setting screen. To
return to the SIP setting screen, press
[B]
again.
"SIP / Video System"
/
"SIP / Audio System"
/
"H.323 / Video System"
/
"H.323 / Audio System"
: Use
[
][
]
to select the item that you want to change and press
[ENTER]
.
•
Checkmarks are added or removed. Codecs without a checkmark are disabled.
•
By default, all are enabled.
Note
•
The setting of
"H.264 / Baseline Profile (PktMode0)"
codec for
"H.323 / Video System"
and the
setting of
"G.722"
codec for
"H.323 / Audio System"
cannot be changed.
•
The setting of
"H.264 / Baseline Profile (PktMode0)"
codec for
"SIP / Video System"
and the
setting of
"G.722"
codec for
"SIP / Audio System"
cannot be changed.
"SIP / QoS"
/
"H.323 / QoS"
: Press
[ENTER]
and use
[
][
]
to select whether to enable QoS.
–
"ON"
(default): QoS will be enabled.
–
"OFF"
: QoS will be disabled.
3.
Press
[G]
.
•
A dialogue box to confirm the saving of settings is displayed.
4.
Use
[
][
]
to select
"Yes"
and press
[ENTER]
.
•
The administrator menu screen is displayed.
Making Security Settings
Settings such as call denied, call history, and USB recording can be made here.
1.
Select
"Security Settings"
and press
[ENTER]
.
•
The security settings screen is displayed.
2.
Select the following items for input using
[
][
]
.
Note
•
The items are displayed across 2 screens. You can display all items by pressing
[R]
to move to
the next screen and pressing
[B]
to move to the previous screen. If you changed the settings, press
[G]
before moving screens to save the settings.
"Incoming Call from a non-regist."
: Use
[
][
]
to select whether to allow incoming calls from units not
registered in the contact list.
–
"ON"
(default): Allows incoming calls.
Document Version 2018-01
User Manual
147
Contacts and Settings
