Note
•
If the value for
"IP Address"
contains 1 or 2 digit numbers, enter these numbers as they are. Do
not enter values such as ".001".
Example: The IP address is [192.168.0.1].
Correct entry: [192.168.0.1]
Wrong entry: [192.168.000.001]
5.
Use
[
][
]
to select
"Target"
and press
[ENTER]
.
•
The multicast target screen is displayed.
Note
•
If no multicast targets with a " " mark displayed are registered in the selection column, the multicast
will not begin when
[START]
is pressed.
6.
Use
[
][
]
to select the
""Not Registered""
target with the lowest node ID, and then press
[B]
.
•
A dialogue box is displayed for selecting the input method.
When "Input Address" is selected
•
The address input screen is displayed.
Use
[
][
]
to select the following items for input:
"Multicast Target Name"
: Input the multicast target name (maximum 24 characters) (Page 158).
"IP Address"
: Enter the IP address.
Press
[G]
.
•
The multicast target screen is displayed.
Note
•
Only IPv4 addresses can be used for the multicast feature.
When "Contact list" is selected
•
The contact list screen is displayed.
150
User Manual
Document Version 2015-08
Using Multicast
