When setting Boundary Microphones as
follows:
Main video camera
R ch
L ch
MIC 2
MIC 3
MIC 1
Display
Speaker
Speaker
Connector
MIC 1:
"Right side"
MIC 2:
"Center Mono"
MIC 3:
"Left side"
Note
•
Make some noise near the Boundary
Microphone.
"
"
is displayed to indicate
which Boundary Microphone picks up the
noise.
•
"
"
is not displayed when the Boundary
Microphone is mute.
•
"
"
is not displayed when multiple
Boundary Microphones pick up the sound at
the same time.
•
When the Boundary Microphone is mute,
the sound made by pressing the MIC Mute
button might make
"
"
appear.
8.
Press
[G]
.
•
A dialogue box to confirm the saving of settings
is displayed.
9.
Use
[
][
]
to select
"Yes"
and press
[Enter]
.
•
The system settings screen is displayed.
10.
Press
[Home]
.
•
The Home screen is displayed.
Note
•
Do not move Boundary Microphones after
completing settings. Otherwise the settings will
not match the location of the Boundary
Microphone.
Making Remote Control
Settings
You can specify a remote control ID from 1, 2, or 3 for
both the remote control and the unit. The unit responds
to signals from any remote control with the same remote
control ID as itself. If you do not specify an ID, the unit
responds to signals from all remote controls. You can
confirm the remote control ID for the unit on the Home
screen (Page 26).
1.
Press
[Menu]
.
•
The Menu screen is displayed.
2.
Use
[
][
]
to select
"Settings"
and press
[Enter]
.
•
The system settings screen is displayed.
3.
Press
[
]
.
•
The second page is displayed.
4.
Use
[
][
]
to select
"Remote Ctrl ID"
and press
[Enter]
.
•
The remote control settings screen is displayed.
5.
Use
[
][
]
to select the following items for input:
"Remote ID enable"
: Use
[
][
]
to select
"ON"
or
"OFF"
(default).
•
When
"ON"
is selected, you can set a specific
remote control ID for the unit.
•
When
"OFF"
is selected, the unit will respond
to all remote controls.
"Remote control ID"
: Use
[
][
]
to select a
remote control ID (
"ID1"
[default]/
"ID2"
/
"ID3"
) for
the unit.
"Check ID mismatch"
: Use
[
][
]
to select
"ON"
(default) or
"OFF"
.
User Manual
87
Contacts and Settings
