Controlling a PTZ Camera
If a PTZ (pan, tilt, zoom) camera is connected as the main video camera to the other party’s unit, you can
control the pan (side-to-side movement), the tilt (up-down movement) and the zoom of the camera during a
video conference call.
Note
•
You cannot control your PTZ camera. If the other party is using a KX-VC300 or a KX-VC600, you will
be able to control their PTZ cameras. If the other party is using a KX-VC500, you will not be able to
control their PTZ cameras.
•
If any of the other parties is using an older software version, you will not be able to control any of the
other party’s PTZ cameras.
•
You will be able to control the other party’s PTZ cameras only if they have set
"CAM ctrl from remote
site(s)"
in their settings to
"ON"
(by default, it is set to
"OFF"
).
•
For details about compatible PTZ camera models, contact your dealer.
•
The features that can be used may be limited depending on your video camera model.
(e.g., A video camera with only a zoom feature)
•
When the other party is using a non-Panasonic video conference system, some operations may not
be available, or unintended operations may occur.
1
Press
[CAM Ctrl]
.
•
The site selection dialogue box is displayed.
Note
•
After the site selection dialogue box is displayed,
if no operations are performed within
approximately 3 seconds, the dialogue box will
disappear.
52
User Manual
C
o
n
t
r
o
l
l
i
n
g
a
P
T
Z
C
a
m
e
r
a
Controlling a PTZ Camera
