5.
Use
[
][
]
to select
"Password"
, then enter the
administrator password (4–10 digits).
Note
•
Please enter the administrator password
that was set during installation.
•
If you forget the administrator password,
please contact your dealer.
6.
Use
[
][
]
to select
"Login"
and press
[Enter]
.
•
The admin menu screen is displayed.
Making Administrator
Password Settings
1.
Login to the administrator menu (Page 92).
•
The admin menu screen is displayed.
2.
Use
[
][
]
to select
"Password Settings"
and
press
[Enter]
.
•
The password settings screen is displayed.
3.
Use
[
][
]
to select the following items and enter
a password (4–10 digits):
"Current password"
: Enter the current password
(default: 00000000).
"New password"
: Enter the new password.
"Retype new password"
: Enter the new password
again.
Note
•
Please change the default login password
the first time the unit is installed.
•
Be sure to keep the password safe.
4.
Press
[G]
.
•
A dialogue box to confirm the changing of
settings is displayed.
5.
Use
[
][
]
to select
"Yes"
and press
[Enter]
.
•
The admin menu screen is displayed.
6.
Press
[Home]
.
•
The Home screen is displayed.
Making SIP Settings
When using a SIP server over an intranet, video
conference calls can be made using SIP URIs (SIP user
name@SIP domain name).
Note
•
Video conference calls to an MCU or a
non-Panasonic video conference system
through a SIP server using a SIP URI are not
guaranteed.
•
When there is a problem with the SIP server, or
when SIP settings are incorrect (on the server
or on the unit), etc., and video conference calls
cannot be made, on the Home screen the SIP
user name is not displayed, and instead
"SIP is
not registered"
is displayed. In this case, you
cannot make calls using IP addresses as well
as SIP. Contact your network administrator.
1.
Login to the administrator menu (Page 92).
•
The admin menu screen is displayed.
User Manual
93
Contacts and Settings
