Installation of this unit
Installation
26
5
Secure the unit to the rack.
≥
Steady
A
to avoid moving the unit on the rack, use the
M5 screws provided in the holes of the mounting
brackets to secure the unit to the rails.
≥
When tightening the M5 screws,
press down on the shoulder of
the module while fitting it to
ensure there is no gap with the
support angle.
≥
Make sure you do not press
near the center of the top
surface as this can cause the
module to become deformed.
Checking for gaps between the module and support angle
6
Attach the module holder bracket.
≥
Attach the module holder brackets to the locations of
the M5 cage nuts using the M5 screws. Attach the
brackets so that they are in contact with the top of the
module.
Bottom Module
Base Module or
Extension Module
ACCEPT
No
Yes
Support angle
Confirm that a 0.5 mm
(0.02
q
) gap gauge cannot
be inserted.
Module
Gap under 0.5 mm (0.02
q
)
Attempt to insert a 0.5 mm (0.02
q
) gap gauge between
the drawer side module and support angle to check
that the module and support angle have been fitted
flat, and ensure that the gauge cannot be inserted.
0.5 mm (0.02
q
) gap
gauge can enter.
1
Remove the module's screws, pull out the
module and remove the mounting bracket.
2
Check that the mounting bracket has been
fitted so that it matches the locating holes.
3
Check that there are no foreign objects in
the fitting parts.
4
Redo the tasks in "Installing in the rack" (
Module holder
bracket
M5 screw
