Installation of this unit
Appendix
64
≥
Lower the clutch lever with your finger until it reaches
the stopper of the changer unit.
≥
Press the right clutch lever to the outside.
≥
Lower the clutch lever with your finger until it reaches
the stopper of the changer unit.
≥
Both clutch levers have been lowered down.
5
Check the changer unit installation.
≥
Confirm that a 0.09 mm (0.004
q
) gap gauge cannot be
inserted between the four changer unit seats at the
front and back and the bottom panel of the Bottom
Module.
≥
If the 0.09 mm (0.004
q
) gap gauge can be inserted,
contact the vendor.
You can check the front through the
opening if the seats of the changer unit
are in contact with the bottom panel.
