13 Point radiation object
Related topics
Position or rotate a point radiation object
Set laser correction parameters for a marking object
13.3 Position or rotate a point radiation object
Set the coordinates to change the position of a point radiation object. Specify a rotation
angle to rotate a point radiation object.
The position and rotation settings are applied to all points set in the selected point radiation
object.
• To edit the parameters of the point radiation object, select the object in the object list or in
the marking image editor.
The parameters are displayed in the category below the object list.
• Specify values for “X-offset [mm]” and “Y-offset [mm]” to change the position of all points
of a point radiation object.
Alternatively, you can move the object by dragging it to a new location in the marking
image editor.
• Under “Position, rotation”, enter a value for “Rotation angle [°]” to rotate all points of a
point radiation object. Enter a positive value for counterclockwise rotation and a negative
value for clockwise rotation.
The rotation center is the center of the marking field.
Related topics
Edit, add or delete a point in an existing point radiation object
ME-NAVIS2-OP-1
143
