15 2D code object
Related topics
15.10 Specify the position of a 2D code object
To position your 2D code object, specify the coordinates of the reference point, the object's
center. Alternatively, move the 2D code object by dragging it to a new location.
1. To edit the parameters of a 2D code object, select the object in the object list or in the
marking image editor.
The parameters are displayed in the category below the object list.
2. Under “Position, rotation”, enter values for “X-position [mm]” and “Y-position [mm]” to
move the 2D code object to a new location in the marking image editor.
Alternatively, select the 2D code object in the marking image editor and drag it to a new
location.
Related topics
15.11 Rotate a 2D code object
To rotate a 2D code object, specify a rotation angle. Alternatively, use the circular arrow
symbol in the marking image editor.
The rotation center is the center of the 2D code object.
1. To edit the parameters of a 2D code object, select the object in the object list or in the
marking image editor.
The parameters are displayed in the category below the object list.
2. Under “Position, rotation”, enter a value for “Rotation angle [°]” to rotate a 2D code
object. Enter a positive value for counterclockwise rotation and a negative value for
clockwise rotation.
To rotate a 2D code object with the circular arrow symbol , select the object in the
marking image editor.
Position the pointer over the symbol. Click and drag in a circular motion.
Related topics
172
ME-NAVIS2-OP-1
