120
2-9-2 Counter
With this function, the counter is increased or decreased per setting setup number from the initial value to end value for
each counter source.
Notice
•
When the counter is interrupted by alarm occurrence etc., check the counter value for the next marking.
Reference
•
The counter does not operate at test marking.
• The current value of the counter is saved without overwriting the file.
•
After setting counter condition here, input the functional character of counter in the character setting screen. Refer to
“Counter” (P.111).
1
6
7
2
4
5
3
Description
1
Counter No.:
Enables to set 4 types of lot conditions from 0 to 3 per file.
Reference
• The common counter (common counters 4 to 7) are settable for all files in common. Refer to “2-13-2 Common
2
Curr (Current Value):
Current counter value. The current value is subsequently marked. Set the current value within the initial value and
end value.
Setting Range
0 to 999999
3
Init / End (Initial Value / End Value):
The initial value and the end value of the counter. When the counter value reaches to the end value, the marking is
started from initial value again.
When the initial value is smaller than the end value: Counting up
When the initial value is larger than the end value: Counting down
Setting Range
0 to 999999
Reference
•
Set the different value to the initial and the end value. If the same value is set to both, the counter value does not
change.
ME-LPMSZ-OP-7
Summary of Contents for LP-M Series
