131
■
Serial data input: SIN
Sets the character string specified for “Serial Data Function” to change characters for each marking.
Function characters (serial data) are preset to the marking character string or bar code data. Marking of the transmitted
character string corresponding with the serial data starts.
Setting of serial data input
STX
SIN
S
[Serial data No.] [Marking data]
Max. 62-byte or Max. 512-byte
(Check sum)
Delimiter
Name
Data length
[byte]
Description
Remarks
Serial data No.
2
“00”–“15”
Marking data
Max. 60
or
Max. 510
•
For marking characters, up to 30
characters can be input with one-
byte or double-byte (Shift-JIS code)
characters.
•
For the code data, up to 255
characters can be input with one-
byte or double-byte (Shift-JIS code)
characters.
It is not possible to use both ASCII
code and Shift-JIS code in one strings.
Reference
•
Only when the internal shutter is opened during the remote mode (“Reception mode ON” (marking interruption) is not set
for command reception permission (MKM command)), the serial data can be transmitted to the laser marker.
•
For using this command, set “serial data” of function characters at setting screen beforehand.
•
When using this function (serial data), transmit this command by every marking. Otherwise it does not become marking
ready condition, and marking is not available.
•
When transmit this command without any data, marking ready become ON, then nothing to be marked with serial data
input.
•
For resetting the data, set the “reception mode ON” (marking interruption) for command reception permission (MKM
command) or close the shutter.
•
SIN command cannot be used with the rank function, external offset and equidistant marking to moving object.
• If SIN command is used with the marking to the flying object, make sure that the marking interval time is enough to the
required period to input the marking data and to confirm the marking ready output.
• In case of transmitting character using the RS-232C which is differed to the specified number of digit, the character is
marked with the differed number of digit.
•
Refer to “Timing chart for serial data marking” (P.49).
ME-LPMSZ-SR-9
Summary of Contents for LP-M Series
