108
3-5-2 Marking trigger input
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T1
T1
T2
READY OUT
MARKING OUT
TRIG. IN
WARNING OUT
(Active Low)
Item
Period
Remarks
T1
10 ms or more
Keep the ON status for 10 ms or more.
T2
2 to 510 ms
It outputs a warning to notify that an invalid trigger was input when a marking trigger was
input during trigger processing. This is One-shot output. You can turn this warning off by
the settings.
ンㄆㄇㄆㄓㄆㄏㄆ
• The marking is started when TRIG. IN is turned to ON while either the delay time or delay distance is 0.
3-5-3 Equidistant marking (flying object marking)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T2
T2
T2
T3
T3
T3
T3
T1
READY OUT
TRIG. IN
MARKING OUT
MARK END OUT
Item
Time
Remarks
T1
―
The time when the work travels the distance set in the “trigger ready.”
T2
―
The time when the work travels the distance set by marking interval.
T3
2 to 510 ms
One-shot output. Set the output time on the environment setting screen.
There is a small margin of error for the setting value.
ンㄆㄇㄆㄓㄆㄏㄆ
• Equidistant marking is performed while TRIG. IN is ON.
• The laser marker stops after marking is completed if TRIG. IN is turned to OFF during marking.
• Equidistant marking is performed after travels the distance that is set in the “trigger ready”.
ME-LPS-SSM-8
Summary of Contents for LP-S Series
