26
8.3.4.
LENS Calibration
1. Preparation of the SD CARD
a. Format the SD card.
b. Put PDCE575C.elf into the SD card on root directory.
2. Setting the DSC for calibration
a. Set the battery to the camera.
b. Insert the SD card.
c. Press shutter button and power button at the same time and continuously until the calibration mode(Fig.4-A) is displayed.
d. Set the Collimator’s Star-chart side to the front of light box.
e. Move the lens to the center of the collimator on the opposite side of the light box.
3. Execute the calibration
a. Select “Lens” (fig.4-B), then press “MENU/SET” button (fig.4-C), then press Shutter button to start the auto CAL process.
b. The parameters will be saved automatically once CAL process finish.
c. The LCD turns green and show “OK”, if succeed, LCD turns red and show NG code if fail.
d.The calibration mode (fig.4-A) is displayed again.
e.Turn off the power to complete calibration.
Summary of Contents for Lumix DMC-LS6P
