S-1
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S3.2. System Control Block Diagram ............................................. S-4
S3.3. Video/Audio Process Block Diagram .................................... S-5
S3.4. Sensor Block Diagram .......................................................... S-6
S3.5. Lens Drive Block Diagram..................................................... S-7
S3.6. Power Block Diagram............................................................ S-8
S4. Schematic Diagram .................................................................. S-9
S4.1. Interconnection Diagram ....................................................... S-9
S4.2. AF Assist Schematic Diagram ............................................. S-10
S4.3. Flash Top Schematic Diagram ............................................ S-11
S4.4. Lens Flex Schematic Diagram ............................................ S-12
S4.5. CCD Flex Schematic Diagram ............................................ S-13
S5. Print Circuit Board .................................................................. S-14
S5.1. AF Assist P.C.B. .................................................................. S-14
S5.2. Flash Top P.C.B. . ................................................................ S-14
S5.3. Lens Flex P.C.B. ................................................................. S-15
S5.4. CCD Flex P.C.B. ................................................................. S-16
S6. Replacement Parts List .......................................................... S-17
S7. Exploded View ....................................................................... S-23
S7.1. Frame and Casing Section (1) ............................................ S-23
S7.2. Frame and Casing Section (2) ............................................ S-24
S7.3. Packing Parts and Accessories Section .............................. S-25
Table of contents
Service Manual
Digital Camera
DSC0602003CE
/ DSC0602005CE
Diagrams and Replacement
Parts List
DMC-LZ3
S
ERIES
DMC-LZ
4
SERIES
DMC-LZ
5
SERIES
Vol. 1
Colour
(S)...........Silver Type
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as " " mark.
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
COMPONENTS IDENTIFIED WITH THE MARK HAVE THE SPECIAL CHARACTERISTICS
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
7.Indication on Schematic diagrams:
OFTR
FEP
Circuit name being connected.
Name of Signal
This signal is connected
to the FEP schematic diagram
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
