12
VQT1Q30
Preparation
-Setting the O-ring- (continued)
4
Inspect the opposite side of the O-ring in the same way.
5
Apply the grease (supplied).
≥
Apply a rice-grain size of grease (supplied) evenly to the O-ring with the tip of
your finger.
≥
Dirt or dust will stick to the O-ring if you apply too much grease.
≥
Use only the specified grease. If you use other types of grease, the
surface of the O-ring may be damaged causing water leakage.
≥
Do not apply the grease with paper or a cloth. The fibers from the paper or cloth
may stick to the O-ring.
6
Fit the O-ring evenly into the O-ring groove.
Check the following:
≥
There is no dirt sticking to the O-ring.
≥
The O-ring has not come out.
≥
The O-ring is not twisted.
≥
The O-ring is not stretched too much.
CORRECT
INCORRECT
VQT1Q30.book 12 ページ ２００８年１月３０日 水曜日 午後２時５４分
