Important
：
6.2.2. Assembly Procedure
Plate and the 2nd Lens Frame Unit
1. When tightening the screw, use a torque driver
1. Install the 2nd Lens Shading Plate.
6.2.2.3. Installation of the 2nd Lens Shading
each step.
cloth to press it into place.
6.2.2.1. Installation of the 5th Lens Frame Unit
(RFKZ0542) with specified torque described in
2. After installing the 2nd Lens Shading Plate, use a soft
1. Install the 5th Lens Frame Unit after aligning
phase mark (
Δ
).
6.2.2.2. Installation of the 3nd Lens Frame2 Unit
1. Install the 3rd Lens Frame2 Unit after aligning
point
②
in the figure below.
3. Install the 2nd Lens Frame Unit.
4. Rotate the arrow
②
point counterclockwise until it
does not rotate when you watch it from back.
6.2.2.4. Installation of the 1st Lens Holder Unit
to the Cam Barrel
1. Align phase mark (
∆
) and rotate the Cam Barrel
counterclockwise when you watch it from back.
※
Install the Cam Barrel while avoiding the 1st Lens
Pin so as not to scratch the surface of the 2nd Lens
Shading Plate.
5th Lens Frame Unit
Phase mark (
∆
)
3rd Lens Frame2 Unit
Point
②
2nd Lens Shading Plate
②
2nd Lens Frame Unit
1st Lens Holder Unit
Cam Barrel
Phase mark (
∆
)
12
