4
A)
Floor nozzle
B)
Connection pipe
C)
Hose
D)
Suction regulator
E)
Curved wand
F)
Telescopic wand
G)
Hose inlet
H)
Dust indicator
I )
Dust cover
J)
ON/OFF Switch pedal
K)
Cord rewind pedal
L)
Crevice nozzle
M)
Dusting brush
N)
Exhaust cover
O)
Plug
P)
Variable power control button
A - IDENTIFICATION OF MAIN PARTS
B - HOW TO ASSEMBLE YOUR CLEANER
C - HOW TO OPERATE YOUR CLEANER
B-1
Insert connection pipe into hose inlet until it locks.
When removing hose assembly, pull out connection
pipe with pushing down two connection buttons.
NOTE:
Do not bend, pull and step on the hose or put
anything heavy on it.
B-2
Insert the hose unit into the upper end of the
connected telescopic wand, and the floor nozzle to
the other end.
B-3
You can adjust the length of telescopic wand by
pushing button.
C-1
Pull out the mains lead and put the plug into the
socket outlet.
C-2
Gently press at the center of the switch pedal to
turn ON the vacuum cleaner.
Press the pedal again to turn it OFF.
C-3
Power control
To increase or decrease the power, turn the variable
power control button.
C-4
Switching between carpet and flooring
Flooring: Press lever A
Carpet: Press lever B
C-5
The curved wand of the hose is attached with a
manual suction regulator, which allows you to briefly
reduce the suction level.
C-6
After you finish vacuuming, remove the plug from
the socket outlet and press the cord rewind pedal.
When rewinding the mains lead, press the cord
rewind pedal by holding the plug so that it does not
become damaged.
C-7
Storage position
Slide the wand holder attached to floor nozzle pipe
straight into the wand supporter on the under side of
the main body.
C-8
Park position
For short breaks during vacuuming, slide the wand
holder attached to the floor nozzle pipe into the wand
supporter on the rear side of main body.
NOTE:
When you use park position, we suggest the
appliance is switched off.
