7
3. Lift the upper body U to separate it from the lower body U.
4.3.
Printed circuit board AU
(P.C.B. AU) removal
1. Remove the Swivel cap unit and Supporter plate U and
Switch cover U.
2. Here is the drawing of the lead wire before the P.C.B. AU
is removed.
3. Disengage the fast-on terminal of the wires (red) and
(blue) which lead to the cord reel partition wall connected
to the printed circuit board AU.
* Caution:
Pull out the fastening terminal without twisting it.
Pull out by holding down the section indicated by an
arrow.