9
5.
a. Take out the motor and detach the motor support rub-
ber (rear) and cushion plate (Fig. 11).
b. Disconnect the lead wires, and detach the noise
absorber and motor support rubber (front) (Fig.12)
6. Replace the motor with a new one.
7. Re-assemble front / rear motor supports, noise absorber
and connect the lead wires to the motor.
8. Re-install the motor and reassemble motor case and
remaining parts in the reverse order.
NOTE: Make sure the lead wires are correctly posi-
tioned to avoid pinching them between parts.
* Connection of Connector A unit during assembly
Connect Connector A unit as shown in Fig. 13 so that
the unit is inserted in the cut of the noise absorber.
4.5.
PC board w/component,
ON/OFF Switch, Fuse unit and
Power cord (Mains lead)
1. Remove the two screws fixing the switch cover unit (Fig.
14).
