3.1.2. Installation
1. Reinstall fastener guide into upper body and reinstall two
(2) screws.
2. Align upper body over lower body. Press down to snap in
place.
3. Reinstall one (1) screw into back of vacuum cleaner.
4. Reinstall dust bag and dust cover.
3.2. Lower Plate
3.2.1. Removal
1. Turn off and unplug vacuum cleaner.
2. Lay vacuum cleaner with bottom facing upwards and nozzle
flat
3. Remove nozzle hose from body by (1) pressing in locking
tab and (2) sliding up and out of retaining slot.
4. Remove four (4) screws from the nozzle cover..
5. Place the vacuum cleaner in the upright position standing
on the handle. This will minimize wheel interference when
removing the lower plate.
6. Remove the lower plate by rotating upward as shown. Use
caution as motor shaft may be hot.
13
MC-UG323-00 / MC-UG327-00 /