7
When circuit breaker automatically stops motor due to overloading, turn off the Switch to "0"
position and follow the instruction below.
CIRCUIT BREAKER PROTECTION
SAFETY LOCK
JUICER
1. Remove accumulated food residue from the
Spinner and the Container Cover. Then cut
ingredients into smaller pieces.
2. Attach parts again (refer to page 8) and resume
operation. Push them gently into the Feeding
Tube using the Food Pusher.
BLENDER / DRY MILL
1. Reduce ingredients to less than half. Resume
operation.
2. If it still does not start, turn off the Switch to “0”
position, then resume.
The safety lock has been designed to prevent
the Blender or the Dry Mill from switching on
when the Blender Container or the Mill Container
is not properly in place.
Do not push the safety lock pins with any
instrument, stick etc.
Attach the Blender Container or Mill Container to
each container base properly.
• After setting, make sure the bottom of each
container base is as shown in the
illustration.
Safety lock pin
None of the three pins
sticks out.
pin
pin
If pin stick out.
g
Reattach the container
again.
