EN5
English
Note
:
• Do not grind hard ingredients such as bones, nuts and frozen meats.
(They may cause jamming.)
• Do not grind ginger and other ingredients with hard fi ber.
(They will not be ground.)
• Do not operate more than 15 minutes at one time.
(It may cause a malfunction.)
• When operating reverse function, do not operate more than 5 seconds.
(It may cause a malfunction.)
• To avoid jamming, do not feed ingredients with excessive force.
If the appliance is jammed due to hard ingredients lodged onto the Feed Screw or the Cutting Blade, switch
off immediately and clean the appliance. When the Circuit Breaker activates, switch off.
(See page EN6 “When meat is jammed inside of the Head”.)
• Do not fi x the Cutting Blade and the Cutting Plate when using the Kubbe Attachments and Sausage
Attachment.
• The Head may wobble slightly during use, but it is normal. Do not overtighten the Locking Knob to stop this
wobbling. It may cause damage. If the Locking Knob gets loosened, tighten the Locking Knob again.
• The Circuit Breaker may be activated easily when grinding large or hard ingredients, but it is normal.
To Assemble
Unplug when assembling the unit. Before plugging in, ensure the Switch is off.
1
Place the Head onto the Opening of the Motor Housing.
• Align the Head vertically before pushing fully into the Opening.
• If the Head is not set properly, the Head is needed to turn right and left slightly to get the
correct alignment before pushing in.
• Hold the Head with one hand and tighten the Locking Knob clockwise.
2
Place the Feed Screw into the Head, long end fi rst, by turning the Feed Screw
slightly until it is set into the slot of the Head.
3
Place the Cutting Blade onto the Feed Screw shaft with the blade facing the front
as illustrated.
• Cutting surface should be faced to the Cutting Plate when being set, otherwise meat will
not be ground.
4
Place the desired Cutting Plate over the Cutting Blade by fi tting the
Protrusions in the slots.
• If the Cutting Plate is not set properly, meat juice may leak out around the shaft in
the Opening of the Motor Housing.
When meat juice leaks out, clean around the shaft in the Opening of the Motor
Housing. Wipe with a well-wrung cloth.
Shaft in the
Opening of the
Motor Housing
Protrusions
Slots
5
Screw the Cap into the Head fi rmly in clockwise direction.
Place the Hopper Plate on the Head and fi x it into position.
Set the unit on a fi rm surface.
• The air vents at the bottom and the side of the Motor Housing should be kept free and not
blocked.
Before Use
Meat_Grinder_MK-GJ1700.indb 5
Meat_Grinder_MK-GJ1700.indb 5
11/14/2018 10:32:18 AM
11/14/2018 10:32:18 AM
