18
疑難排解
問題
可能原因
頁面
即使將選擇器旋鈕設至「1」
或「2」的位置，攪拌機仍無
法運作。
• 攪拌機容器組立與碾磨機容器組立沒有正確安裝於本體上。
• 電源插頭已從電源插座斷開連接。
• 食材阻塞了刀片的運轉。
參見第 9
和 12 頁
使用中途停止運轉。
• 啟動了馬達的斷路器保護裝置。
檢查容器中是否有放入禁止、硬質、或過多的食材。
• 當聽見異常聲音或產生高度震動的情況時，斷路器保護裝置也會啟動。
參見第 15
頁
食物洩漏。
• 沒有正確裝上攪拌機容器或碾磨機容器。
• 沒有安裝墊圈。
參見第 7、
9 和 12
頁
Troubleshooting
Problems
Possible cause
Page
The blender will not operate
even when the selector
knob has been set to the “1”
or “2” position.
• The blender container or mill container is not mounted correctly on the
motor housing.
• The power plug has been disconnected from the power outlet.
• The ingredients are clogging the cutter.
See P.9 &
P.12
The blender stops operating
midway through operation.
• The Circuit Breaker Protection of the motor has been tripped.
Check whether prohibited, hard or too many ingredients have been
placed in the container.
• The Circuit Breaker Protection will also be tripped when abnormal
sounds are heard or high levels of vibration are generated.
See P.15
The ingredients being
processed are leaking out.
• The blender container or mill container is not mounted correctly.
• The gasket has not been installed.
See P.7 &
P.9 & P.12
0_MX-151SG1-050.indd 18
2010/05/24 11:31:17
