36
37
37
Troubleshooting
Installation
Service person only
Error Display
Unable to drain
What to do
Check the drain hose for any of following problems:
-It is blocked with debris .
-Hose tip is immersed in water .
-It extends further than 3 m .
-Water in the pipe is frozen .
Clean the drain fi lter if blocked. (P. 31)
After correcting the problem, open the door then close it, then
press the start button to restart the machine .
Door is open
What to do
Make sure that door is closed properly .
Close the door securely and press the start button .
Unable to spin-dry
The product has been designed to detect unbalanced loads,
particularly small loads, in order to ensure quiet operation and
achieve the best results .
This is not a malfunction . Perform any of the following solutions .
What to do
-Please try to untangle clumps of clothing .
-If you wash large items, e .g . blankets, please reduce the load .
-In case of very small load, add one or two bath towels .
-Please check that your product is on a stable surface .
-Please adjust the feet to ensure the machine is level .
After correcting the problem, open the door then close it, then
press the start button to restart the machine .
Unable to supply
water
What to do
Check for any of following problems:
-Supply tap is closed .
-Water pipe or hose is frozen .
-Water supply has been disrupted .
-
Water supply fi lter is blocked. (P. 29)
After correcting the problem, open the door then close it, then
press the start button to restart the machine .
If the red mark appears in the hose with a water supply valve,
the water supply has stopped .
Replace with a new hose .
Hose with water supply valve (No . AXW-598865)
An error starting with “H” is displayed .
What to do
Press the Off button . If the display stays on, or if the error
message appears again when you press the Start button, unplug
the machine and contact your local Customer Service Centre .
Choosing the Right Location
z
Make sure to ask a service person for installation . Do not install by yourself .
z
If the installation, test run and inspection of the washing machine are not
carried out following this installation method, Panasonic will not be liable for
any accident or damage caused .
Appliance dimensions
(d)
(e)
(c)
(a)
(b)
Locations the appliance is not to
be installed
-In a damp place or where the
appliance may be exposed to rain,
etc . (As this could cause electric
shock or fi re)
-Locations that are uneven, or
unstable (As this could cause
vibration and noise)
-In direct sunlight (As this
could cause a malfunction or
deformation)
CAUTION
Do not install where temperatures
may reach freezing .
Set-in installation
-Install the appliance with easy
access to the mains plug and
socket .
-Install the appliance where there is
enough space around it .
(a): 3 mm or more above
(b): 3 mm or more behind
(c): 2 mm or more on the left side
(d): 2 mm or more on the right side
(e): 60 cm or more
