Panasonic NA-F62G6, Service Manual

NA-F62G6 / F65G6 / F70G6 / F75G6 / F75S6 / F70S6

12

7 Troubleshooting Guide

7.1.

Test Running without water

< Method to test running without water >

1. Set the power switch to [OFF].
2. Press and hold both the [Process] and [Power Soak] buttons with one hand.
3. Press the power ON button.
4. Release the your fingers from the buttons and power switch which you pressed in steps 2. and 3. above.

(Check A can be carried out in this state with your fingers released.)

5. Within three seconds, press the [Process] button to set to the desired check procedure as follows.

Number of times 

the [Process] 

button is pressed

Check

 Procedures

Check contents

Lamp illumination condition

Operation condition

• End signal
• Auto power-off

• The end buzzer sounds three times

after operation is finished.

• The lamps as shown in figure will simul-

taneously flash on and off and the
power will automatically be switched off.

• Abnormal in memory storage.

It should be indicated [02].

• In case of the end buzzer is [switched

off],[Child Lock] will be switched on. 

• Abnormal signal of 

memory:
[H05] will be displayed.

• Indication of [H17] is 

given for thermister 
error.

• Even if there is no water in the tub, the 

washing operation will continue for six 
minutes.

• Press the [Program] button to change 

the current.
Every 1 second, wash current will be 
changed.
[Normal] - [Gentle Hand Wash]
Normal current : LED display [1] for 5 
seconds.
Gentle Hand Wash current : LED dis-
play [5] for 5 seconds.

• Pressing  [Power Soak] is able to switch 

over  program(agitation 



 water supply 



 hot water supply).

• Spin operation check.
• Abnormal signal of lid 

switch and SF switch.

• The spinning operation will continue for

six minutes.

• SF SW 2 OFF(Open the lid) [hours]

lamp On.

• SF SW 1 OFF(Open the lid) [Reserve]

lamp On.

• SF SW 1 and 2 are both OFF. Buzzer

notifying that the lid is open while the
tub is rotating.