Installation Instruction of Rat Resistance Panel (Type A)
The rat resistance panel shall be installed before disassembling the transporting
and the installation shall be done by at least two people.
First, tear off the paper on the surface of the foam tape.
Second, incline the washing machine in back direction to a suitable angle for purpose
of installation. Please don’t damage the machine surface when inclining the washing
machine.
Third, insert the rat resistance panel by its intended direction requirement to
the correct position:
side
④
shall be inserted on the cabinet rear flanging .
side
①
and side
③
shall be positioned on the left and right bottom brackets.
Last, stick the side
②
on the cabinet rear flanging with foam tape.
First step
①
②
③
④
④
①
②
③
④
Back
①
②
③
Front
Third step
Last step
①～④：
The foam tape position
Second step
Summary of Contents for NA-S107F2WBZ
