12
• If detergent or softener is attached to the main unit (especially door, operation panel and touch panel),
immediately wipe it off with a wrung-out towel, etc. (Peeling of print, damage to resin, metal corrosion or
malfunction may occur.)In particular, if liquid concentrated detergent is attached to the resin part, it may crack.
• If you have forgotten putting in the detergent or water is already in the drum, put the detergent in the detergent
case and pour with a cup of water. (Because water to flow the detergent is not supplied)
●
●
You can use powder detergent, liquid
detergent, liquid soap.
●
●
Liquid soap is easy to solidificate, so
dissolve it in the warm water before use.
(Do not use liquid soap when using Timing,
so as to prevent leakage or malfunction
caused by solidification).
●
●
low foaming detergent is recommended
●
●
Do not use soap
powder.
(to prevent dissolve
difficulty in water,
blockage problem,
leakage or
malfunction)
※
■
Detergent
Powder
(detergent/bleach)
●
●
To prevent the detergent from remaining
• Wipe the case if it is wet.
• Break block of detergent before putting in.
Note
Liquid (detergent/bleach)
●
●
Do not use chlorine-based bleach when using the Timing
reservation. (Leaving the appliance for a long time may result
in metal corrosion or malfunction.)
●
●
Do not use chlorine-based bleach for coloured clothes. (Loss
of colour may occur.)
Softener
●
●
Dissolve in water if it is diff
cult to flow.
(Max.: approx. 100 ml)
• Do not put the softener
exceeding the guideline
“MAX” position.
(The softener flows out quickly and no effect is given.)
●
●
Do not leave the softener in the softener compartment for 12
hours or longer. (It easily becomes hard.)
●
●
Do not use a separated or solidified softener.
(The softener or water may remain in the case.)
●
●
Small amount of softener may remain in the case due to its
siphonic structure. (This is not a malfunction.)
Undiluted
softener
(Same amount of)
water
Do not use soap
powder
How to put in the Detergent & Softener