How to use
37
Decompose water into fine particles
through high voltage, and transfer the
produced "nanoe
TM
X" to the tub, allowing
it to enter the deep layer of the clothes to
function and decompose sebum and dirt,
and perform sterilization and deodorization
(of cigarette odor, etc.).
✽
The effect will vary depending on the amount
of laundry and the type and degree of dirt.
●
"Preset" cannot be used.
●
The program will change after each click.
1
On
Off
Turn on the power
3
Start
Pause
Start
The program ends when
the buzzer sounds;
take out the laundry
immediately
(wrinkles will
occur if left untreated).
2
Select "Pre care"
"Refresh (rotate)"
"Refresh (static)"
Prepare
①
Put the dry clothes in the washing tub
●
Please wipe off the water droplets in the
tub.(if the clothes or tub is wet, it will not
have any effect)
●
At "Refresh (static)", please
spread out the clothes as
much as possible and stretch
the wrinkles before putting the
clothes in.
②
Close the door
●
If too many clothes are put in, the machine will
run, but the effect will be very weak.
<Capacity> Pre care: 3 k
g
or below
Refresh (rotate)/Refresh (static): 1 k
g
or below
Flashing
Attention
˙
Please keep the filter clean; the effect will be
reduced if it is clogged with cotton scraps.
˙
nanoe
TM
X programs cannot remove dirt.
˙
Do not put any detergent, softener or
bleach.
Use nanoe™ X
Refresh (Rotate) / Refresh (Static)
Pre care
3 1
2
NA-V180HDH(s)_160HDH(s)-English.indb 37
2022/6/10 下午 10:27:25