25
7.5.
Upper antenna
1. Remove ceiling plate by gently moving the left and right
tabs inward while pulling the plate down and outward.
2. Using a small flat screwdriver or the like, remove two
plastic clips located on the antenna ring. Next turn the
antenna ring approx. 1/8 turn clockwise to unhook the
tabs and pull off.
7.6.
Floor shelf and Lower antenna
1. To remove the floor shelf, insert a screwdriver through the
small opening on the left side of the oven cavity and care-
fully lift the floor shelf.
2. For removal of lower antenna, use the same procedure
as upper antenna.
Summary of Contents for NE-2153-2EYG
